admin_zero

The turbine flowmeter has high accuracy, a wide measurement range, and easy to install. But the measurement signal is easily affected due to the influence of various external factors, the interference is serious, and there is the danger of power failure, so the accuracy of conventional turbine flowmeters fluctuates and the error is large. And […]

The turbine flow meter with analog output has the feature of pressure loss is small, and the impeller has anti-corrosion function. It adopts advanced ultra-low power consumption single-chip microcomputer technology, which has strong functions, low power consumption and superior performance. Intelligent flow indicator with nonlinear precision compensation function. The accuracy of the correction formula is

The turbine flowmeter is widely used in many industrial applications, such as petroleum, the chemical industry, medicine, and so on. So it is necessary for us to have a new understanding of the turbine flowmeter. When the liquid turbine flowmeter is installed, the general strainer is installed at the position of 10DN at the front

The liquid turbine flowmeter is a viscosity-sensitive flowmeter. When the fluid viscosity increases, the linear region of the meter coefficient becomes narrower, and the lower limit flow rate increases. When the viscosity increases to a value, even the wireless region. The situation with spiral blades is much better than with straight blades. For liquids, the

Turbine flow meter low flow, if it is lower than the lower limit of the measurement, it may not be displayed, or the accuracy may not be good. Make sure to measure the flow rate at 5% of maximum flow.

As a common precision instrument in modern industry, a turbine flowmeter is simply an instrument used to measure fluid flow in pipes or open channels. The development of measurement can be traced back to ancient water conservancy projects and urban water supply systems. In the ancient Roman Caesar era, orifice plates have been used to

Required Lengths of Straight Runs Flow altering devices such as elbows, valves, and reducers can affect accuracy. See the diagram below for typical flow meter system installation.   The recommended guidelines are given to enhance accuracy and maximize performance. The distance given here are minimum requirements; double them for desired straight pipe lengths. Upstream: allow

Turndown ratio is also commonly referred to as rangeability. A turbine flow meter measurement Ratio Standard is 10:1 and has an Option of 20:1.

The installation of DN200 Plug-in type target flowmeter. The application is for air. Others application such as air and Chlorine gas.