admin_zero

How they work A turbine meter is a name given to one particular type of rotating flow meter. It consists of a short length of pipe in the center of which there are two bearings supported by spiders. A propeller, large enough to fill the cross-section of the pipe almost completely, is mounted so that […]

Exterior The appearance of the flow meter should be complete and good, and the markings (nameplate, flow direction mark, explosion-proof mark, manufacturing measuring instrument license, etc.) should be correct, complete, and clear. There should be no scratches and other damage on the connecting surface of the external connection. Fasteners should be combined. It is firm

Factory inspection Each flowmeter must be inspected to be qualified before leaving the factory. Only when all inspection items are qualified can the flowmeter be determined to be qualified, and repairs are allowed if there are unqualified items. Timing of type evaluation Type evaluation must be carried out when one of the following conditions exists:

Flow coefficient calculation The flow coefficient of the flowmeter is calculated by the formula (1): ·················（1） The flow coefficient is related to the diameter of the measuring tube, the diameter of the target plate, the flow rate of the measured medium, the properties of the measured medium, and the performance of the sensor. It is

Basic parameters and performance Normal working environment conditions Ambient temperature： -35℃~70℃ Relative humidity:10%~95% Atmospheric pressure: 86kPa~106kPa Nominal diameter The nominal diameter of the flowmeter should be selected from the following values, the unit is millimeter (mm) 10, 15, 20, 25, 32, 40, 50, 65, 80, 100, 125, 150, 200, 250, 300, 350, 400, 450, 500,

The correct selection of the target flowmeter can ensure the better use of the target flowmeter. What kind of target flowmeter should be selected according to the physical and chemical properties of the fluid medium to be measured? The diameter, flow range, and output mode of the target flowmeter can be adapted to the nature

Main index and display Index Medium Liquid, Gas ，Steam, and LPG Caliber Pipe type 15~300mm Clamp type 15~600mm Plug type100~2000mm Pressure 0.6~10MPa 0.6~42MPa 0.6~42MPa Medium Temperature -196℃~+450℃ ( Confirming the temperature range before purchase) Precision ±0.2% ±0.5% ±1.0% ±1.5% ±2.5% Range 1:03 1:05 1:10 1:10 1:10（Steam） Compensation Temperature compensation; Pressure compensation Repeatability 0.1%~0.08% Power Supply

There are three main possibilities: One is that the sensor has no output. Solution method:For flowmeters with batteries, check whether the batteries are installed securely, whether the contacts are good, and whether the batteries are electricity. For the external power supply, check whether the connection between the connecting wires is intact and whether the wires

The following info is from Krohne Webinar, Zero Instrument prepare. Necessity of Grounding Grounding: Protective Ground (PE) & Functional Ground (FE) Methods of conventional Functional Ground (FE) Problems with conventional Functional Ground (FE) Improvements in conventional Functional Ground (FE) Summary Necessity of Grounding Electromagnetic flow measurement (Faraday’s Law) ●The induced signal voltages are very small: